Jm GRAIN CARTS Leaner Setup Manuel d'utilisateur télécharger pdf (Page 12)

STEP - T3.0

STEP - 1.0

STEP - T4.0

-11-

Use a pair of vise grips or extra set of hands to temporarily hold the 2 pieces of drip edge (Detail

#4) to the newly ipped out sideboards with the bolt holes lined up. Bolts in a later step will secure

the drip edge. (The drip edge should be centered from the front to the rear of the cart.) Make sure

that the drip edge is ush to the inside of the sideboard.

Bolt together each sets of the end caps using 1/4”-20 x 1/2” button SKT cap bolts and 1/4”-20 serrated

ange hex nuts. One set of end caps will have a windlip sticking up and the other will be sticking down.

The endcap that has the 1” wind lip sticking up is the front endcap.

Use two 1/4”-20 x 3/4” hex bolts, two 1/4”-20 centerlock hex nuts, four 3/8”-16 x 1” serrated ange hex

bolts and four 3/8”-16 serrated ange hex nuts to attach each of the end caps. The end cap is pre-

drilled, however, 1/4” holes will need drilled through the top of the sideboards and 3/8” holes will need

drilled through the endboards to match the endcaps hole pattern.

1/4” x 1/2”

1/4” x 5/8”

Drilled and installed

after end cap is

bolted to Grain Cart.

1/4” x 3/4”

3/8” x 1”

LEANER MODEL GRAIN CART TARP INSTALLATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Jm GRAIN CARTS Leaner Setup Manuel d'utilisateur Page 12