Jm GRAIN CARTS Leaner Setup Manuel d'utilisateur télécharger pdf (Page 14)

STEP - T6.0

STEP - 1.0

STEP - T7.0

-13-

STANDARD GRAIN CART TARP INSTALLATION

Runtheridgecablesthroughthe3augersideslotsinthefrontendcapsothatthenutandwasherstop

thecablefrompullingthroughtheslot.Pullthecablesoverthetarpbowsdowntotherearofthecart.(If

needed)Drillthree3/8”(10mm)holesintherearendcap2”belowthethreehighestslots(threeslotsclos-

esttoaugersideofcart)intheendcapsatplate.InserttheJ-hooksintherearendcapfromtheinsideand

put3/8”(10mm)centerlockinghexnutoneach.Runtheridgecablesthroughtherearslotsandloopthe

cablearoundtheJ-boltwiththecableclamp.Tightenthe3/8”centerlockinghexnutontherearJ-hookuntil

theridgecableisbroughttight.GrindanyexcessboltstickingoutfromtheJ-bolts.Coverlooseendswith

electricaltape.Theelectricaltapecoveringloosecableendswillpreventweartothecanvastarp!

Slots in end caps

Cable clamp and

ridge cable loop

J-hook

Install the Spring Return on the front of the grain cart using ten 1/4”-16 x 3/4” long self tapping bolts on

the front of the grain cart. It should be placed as far to the opposite auger side as possible and as high

as possible. The pulley wheels should be pointing to the opposite auger side of the grain cart. Try to

get the spring return as high up on the wall of the grain cart as possible, while keeping it level. This will

help prevent any collisions with the upper auger.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Jm GRAIN CARTS Leaner Setup Manuel d'utilisateur Page 14