Jm Roll Tarp GRAVITY BOX (Since 2011) Manuel d'utilisateur télécharger pdf (Page 11)

STEP 8 - TARP BOWS

STEP 9 - CABLE

STEP 10 - PLASTIC STANDOFFS

Using 1/4” x 1 1/2” self tapping screws mount

the Plastic Standoffs 2” below the drip edge and

right up against the corner brace as shown on

the left.

STEP 11 - 1” SQUARE TUBE

11.1 Insert the 1” 14 ga Square Tube into the tarp sleeve on the opposite side of the stiffening patch (see pg. 11,

Step 13 for a picture of the stiffening patch).

11.2 Center the 1” Square Tube inside the sleeve. This should leave around 2” of the tube sticking out of the

sleeve on each side as shown above.

11.3 Use a 1/4” drill bit to drill a hole through the Canvas Tarp and one wall of the 1” Square Tube. The hole

should be around 3/4” from the edge of the tarp.

11.4 Use a hammer to install a 1/4” Drive Rivet.

11.5 Repeat Steps 11.3 & 11.4 at the same location on the other end of the Square Tube.

-NOTE: Be sure the Tarp is pulled tight over the Square Tube in between the Rivets.

3/4”

2”

1 2 ... 6 7 8 9 10 11 12 13 14

Pas de commentaire

Jm Roll Tarp GRAVITY BOX (Since 2011) Manuel d'utilisateur Page 11