Assembly Instructions (Continued)
Step 2:
Lay out the frame halves and extension on the top of the combine as shown. Attach extension angles to frame halves using
(8) - 3/8” x 1” Flange Bolts.
NOTE: The Left Frame half has a notch cut out of the angle iron.
Step 3:
Drill holes through the four weld on tabs and secure to the combine tank with (4) 3/8” x 1” Flange Bolts and Flange Nuts.
Step 4:
Lay out the corner panels as shown and attach using (8) 3/8” x 4 1/2” Bolts and 3/8” Lock Nuts.
Step 5:
Attach the side panels to the frame using (4) 1/4” x 4 1/2” Bolts and 1/4” Lock Nuts.
Step 6:
Attach the front and rear panels to the frame using (4) 1/4” x 4 1/2” Bolts and 1/4” Lock Nuts.
(NOTE: The panel with the Danger decal should be used as the Rear Panel.)
Step 7:
Push the plastic plugs through the retainer lanyards and into the existing holes from inside extension. Fold end of lanyard
around lynch pin ring and snap into place.
Step 8:
Remove existing sensor from current position. Install Sensor Mounting Bracket on panel using (2) 5/16” Flange Bolts and
5/16” Flange Nuts. Bolt the sensor to the Sensor Mounting Bracket and reconnect with the Extension Cable provided.
Combine Grain Tank Set-Up Instructions (Continued)
for John Deere 9550, 9560, 9650 and 9660 Walker Series Combines
Folding the Panels
Step One:
Fold the side panels toward the middle of the
combine hopper.
Step Two:
Fold the front and rear panels inward.
Step Three:
Fold the four corner panels.
WARNING:
Use of this product is at the owner’s discretion. Increasing grain capacity may adversely affect center of gravity,
stability, and controllability. Exceeding maximum combine weight loadings can risk structural integrity and drive
line components. J. & M. Mfg. Co., Inc. does not assume any liabilities, or make any warranties regarding the
performance or structure of the combine. See combine owner’s/operator’s manual for specific limitations, operating
recommendations, and safety information.
J. & M. Mfg. Co., Inc.
P.O. Box 547 Ft. Recovery, OH 45846
Ph: (419) 375-2376 Fax: (419) 375-2708
www.jm-inc.com
Step 9:
On the grain tank extension rear panel, position the step
approximately 8” from the lower side of the panel and directly above
the step in the combine tank. Using the step as a template, mark
and drill two 13/32” holes in the rear panel. Attach the step using
(2) 3/8” x 1” Flange Bolts and Flange Nuts. NOTE: Be sure the
step is positioned and mounted as shown.
(15 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels