Pg. 9
SET-UP INSTRUCTIONS
IMPORTANT: Set-up work to be performed by qualified servicemen only.
1. Mounting the Rear Axles
Secure the Dura-Flex Axles to the axle mounts located on the
underside of the Header Transport Main Frame using four 5/8” x 1-
3/4” Grade 5 bolts with eight 5/8” flat washers and four 5/8” locknuts.
NOTE: The axle should be positioned so the spindle is located
toward the rear of the axle centerline.
2. Mounting the Tires
Secure one tire and wheel assembly to each of the rear hub
assemblies using the wheel nuts provided. Use a star pattern to
tighten the spindle nuts according to SAE standards.
3. Mounting the Rear Fenders
Place one of the Base Fender Support Rail (left or right) on top
of the two rear axles between the main frame and spindle as
shown. Align the holes in the support rail with the rear axles and
loosely secure to each axle using one 3/8” x 3 1/2” x 3 1/2” U-
Bolt, two 3/8” flat washers and two 3/8” lock nuts.
IMPORTANT: Be sure the vertical face of the support rail faces
the outside of the transport (toward the tires) and the support rail
extends farther behind the second rear axle than it does the first
rear axle. If the support rail does not project farther behind the
second rear axle, the rail is located on the wrong side of the
transport and the other rail should be used.
Repeat on opposite side of transport.
Slide the Fender Support Arm across the header transport main
frame and loosely secure to the Angle Iron Support using two
1/2” x 1 1/2” Grade 5 bolts, two 1/2” washers and two 1/2” lock
nuts. Mount the Fender to the top of the Fender Support Arm
using two 3/8” x 1” flange bolts, two 3/8” rubber/metal washers
and two 3/8” whiz nuts. Be sure the side tear drop of the fender
is located toward the outside of the transport. Slide the Fender
Support Arm along the main frame until the fender is centered
above the tires to ensure proper clearance.
Repeat on opposite side of transport.
Mount one Fender L-Brackets to the front and rear end of the fender using two 3/8” x 1” flange bolts, two
3/8” washers and two 3/8” whiz nuts. Secure the other side of the L-Bracket to the Base Fender Support
Rail using two 3/8” x 1” flange bolts and two 3/8” whiz nuts. Repeat on opposite side of transport.
Base Fender
Su
ort Rail
Fender
Support
Arm
L-Bracket
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels